Dose any body have any problems that need attending to..  All's you have to do is ask..

I have a 901 atomizer that is about a month old. It worked very well until a few days ago, when the vapor output begin to drop off. I soaked it over night in vinegar, rinsed it in hot water, dried it and added 2 drops of liquid. I then put on a fresh cartridge and gave it a try. I get on vapor at all. The atomizer heats up right away, warm to the touch. Any idea what is going on?

HI, Did you blow out the the atomizer..  Take it off the batt , and take off the cart. Blow thru the batt end twords the cart end.. If you get a lot of juice coming out then blow some more.. Put 1 drop in and use the empty mouth piece you got with the kit.. Use easy draws to see if it works.. Also check the batt.. Were it screws to the atomizer make sure it is dry.. some times juice can stop it from working..

and you should buy some spare batts and atomizer.. Just incase the parts go bad.. Allways have spares.. 

This isn't really a problem but I do have a question and don't know where else to ask. Are the battery chargers universal? Can I use a charger for the 901 for the 801 or the one I got from smokingeverywhere? I know the cigar chargers are different but from looking at the pics in the sites most of them look the same almost. If anyone can answer this I promise I will dance at your wedding. Thanks!

Some juice seeped into a PS battery, and now it "sticks" (sometimes it doesn't activate when you drag on the mouthpiece). Is there any way to "unstick" the battery? It is otherwise functional.

Battery Chargers are usually not universal, with theexception of a few...like 901's seem to work, no matter who makes them...

What is the best method to "draw" in order to get the maximum amount of vapor from an e-cig. For example, you want to obtain the most smoke from a Screwdriver, or a Prodigy: The cartridge is full, and you have dripped. How do you draw to maximize the amount of smoke?

I draw deep into my lungs. Not a hard draw an easy draw.. Around 4 secounds.

Thanks! I was drawing too fast, I think. Using your method with my SD, I am getting what I want.

Now, for the second [stupid] question, if I'm setting my SD down for an hour, what is the best position to leave it in? Upright, button down: in an ashtray, mouthpiece up, button down; or horizontal? I seem to be flooding attys, and I'm not a dripper.

If the threads work (Rarely) and the voltage is the same... usually

Can I use my (manual switch) Screwdriver as a testing device for my attys?
For example: if I put a clean and dry PS atty on my PS Screwdriver, press the button, and hear no hiss and see no glow, does that mean my atty is dead?
Thank you.

also check that the batt or atty power tab is touching..  If they are then it is dead...  That goes for all ..  even pass thrus

Where is the "power tab?"